Bottom Slitter Knives

MEW Offers extremely wear-resistant cutting tools and solutions for modern state-of-the-art high-performance paper and printing industry.

Machines:

Knives for standard machine makes such as Beck, Bielomatik, Clark Aiken, Datm, Didde, ECH Will, Harris, Hamblett, Jagenberg, Langston, Lenox, Maxson, Miltex, Masson Scott, Pasaban and many others.

Material Grades:

SAE 52100, AISI D2, D3, Tungsten Carbide Tipped (TCT)

Raptor Series:

MEW Raptor Series (RS) Carbide Bottom Bands are made from hardened steel– complete with tungsten carbide inlay– and are ground to a micro-finish on both cutting edge and outside diameter. The precision mirror finish combined with the sharp cutting edge creates a dustless cut time after time. Also, the bottom knife is harder than the top knife, preventing the usual burr from forming on the top knife during high-speed slitting– usually a major contributor to dust creation.

The Raptor Series (RS) bottom knife companion is just as important as the top slitter. Both knives must work together to enhance system performance and reduce problems caused by dust.

Our bands are made from high-grade carbide steel to give you 30-50% higher performance than any other carbide on the market and stay sharp for up to 20 times longer than standard steel knives.

Standard Features:

• Surface roughness Ra 0.10 μm
• Recess bevel 4°
• Axial runout 0.02 mm
• Radial runout 0.03 mm
• Parallelism 0.01 mm